Did you heard of etch 6L FPC to be 2L FPC?

We received a special project, one of our customer need 2L FPC, and want the thickness between two copper layers to be 0.15mm. Because this customer is specialized in RF product, he need so thick dielectric(0.15mm) between two copper layers.

What does it means?

  1. Firstly, for adhesive material, it means “adhesive + Polyimide + adhesive” should meet 0.15mm. If Adhesive is 25um, two adhesive layer totally 50um, the minimum Polyimide thickness will be 4mil.
  2. Secondly, for 4mil Polyimide, it usually refers to adhesive-less material. So if deduct 50um adhesive, it require 6mil adhesiveless material. 6mil adhesiveless PI is very hard to purchase, need to customize, have MOQ limit, and lead time will be very long.

Is there any solution to meet customer’s need?

After discussed with our engineers and manufacture department, we put forward one suggestion. Draw an stack up with 6L FPC, it’s made up of three double-sided FPC. Etch out one copper layers in TOP and Bottom double-sided FPC. And for the middle double-sided FPC, we’ll etch out two copper layers, only leave Polyimide and adhesive. 

By doing this, it finally will only leave two copper layers, and the thickness between two copper layers is 0.15mm. (As below stack up show)

To be honest, when customer put forward to his design requirement, I was amazed, 0.15mm material is so hard to purchase. But our engineers and manufacture department find a good solution for our customer. Our customer are satisfied with our work.

If you have similar need, pls feel free to contact us. We can help you make it come ture.

You may also like

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.